Download EPM1000 User`s Guide

Transcript
Maintenance, Service, and Calibration
Fuse Replacement
The EPM1000 has no user-serviceable parts other than the replaceable
fuse located on the rear panel. Replace the fuse by using a small flathead screwdriver to carefully pry the fuse holder from the power entry
module. Use only a 240VAC/1A fast-blow fuse. Locate a spare fuse in
the removable fuse holder.
Figure 13: Removing the EPM1000 fuse, and the spare fuse compartment.
!
Caution
Instrument
Calibration and
Service
Caution: If the EPM1000 blows two or more fuses in a short period of
time, turn the unit off, disconnect it from the AC supply, and contact
Molectron Detector, Inc.
To maintain optimum NIST traceable performance, return the EPM1000
to Molectron Detector, Inc., for annual calibration and maintenance.
To prepare and ship an EPM1000 to Molectron Detector, Inc.:
1. Call Molectron for a Return Material Authorization (RMA)
number.
2. Attach a tag to the EPM1000 indicating the owner's name
and address, the person to contact, the serial number, and the
RMA number.
3. Wrap the EPM1000 with polyethylene sheeting or equivalent
material.
4. If the original packing material and carton are not available,
obtain a corrugated cardboard shipping carton with inside
dimensions at least 15 cm (6 in) taller, wider, and deeper than
the EPM1000. The shipping carton must be constructed of
cardboard with a minimum 170 kg (375 lb) test strength.
Cushion the unit in the shipping carton by tightly packing
dunnage or urethane foam on all sides between the carton
and the EPM1000. Allow 7.5 cm (3 in) on all sides, top, and
bottom.
EPM1000 User’s Guide
45