Download MOBILITY Extension

Transcript
Technical Description and Installation
2N - MOBILITY Extension
The module contains one 4-wire BRI interface, or 2B+D, which enables establishing
of two calls at the same time. It is designed for connection to the public ISDN and
supports both the PTP and PTMP modes.
• In the PTP (Point-to-Point) mode, the DDI is supported (i.e. so many successive
numbers as the user requests from the ISDN provider). No other ISDN terminal
equipment can be connected to the line.
• In the PTMP (Point-to-MultiPoint) mode, the MSN addressing is supported.
The module is equipped with an RJ-45 connector, which can be used if the
network terminator box (NT1, NTBA) is directly at the ME, i.e. the connecting cable
is not longer than 3 m.
always open
(for test purposes only)
J1
J2
J4
J3
Indicates B2 channel busy
Indicates
B1 channel busy
status
MFEL2 - Layer 2 synchronization
status
Layer
O.K 1 synchronisation
.
O.K
Error / Test: no light during normal
operation
JP1
J5
J6
1.
2.
1. Non-connected jumpers - the ISDN
line leads to J2 only.
2N - Mobility Extension
1.
2.
1. Both two jumpers connected - the ISDN line
is terminated with 100 resistors.
This option is used when the ISDN line is
terminated here, always in PTP connections, e.g..
WARNING! Only on condition that the terminating
resistors ARE NOT in the ISDN wall socket
or other ISDN terminal equipment!
2. Non-connected jumpers - the 100 terminating
resistors are disconnected.
23