Download NJ-series Motion Control Instructions Reference
Transcript
3 Axis Command Instructions Timing Charts • Busy (Executing) changes to TRUE at the same time as Execute changes to TRUE. Active (Controlling) changes to TRUE in the next period. • InVelocity (Target Velocity Reached) changes to TRUE when Velocity (Target Velocity) is reached. • If another instruction aborts this instruction, CommandAborted changes to TRUE and Busy (Executing), Active (Controlling), and InVelocity (Target Velocity Reached) change to FALSE. Execute InVelocity Busy Active CommandAborted Error ErrorID 16#0000 Velocity Decelerates to a stop when another instruction causes an error. Target velocity Time The InVelocity (Target Velocity Reached) output variable indicates when the velocity has reached the same velocity for this instruction and the re-executed motion control instruction. Therefore, after InVelocity (Target Velocity Reached) changes to TRUE, even if the velocity is changed by the override factor, InVelocity (Target Velocity Reached) will not change to FALSE. If the override factor changes before InVelocity (Target Velocity Reached) changes to TRUE, InVelocity (Target Velocity Reached) will change to TRUE when the new target velocity is reached. 3-78 NJ-series Motion Control Instructions Reference Manual (W508)
Related documents
NJ-series CPU Unit Motion Control User`s Manual
NJ-series CPU Unit Motion Control User`s Manual
Robot-supported NJ Series CPU Unit User's Manual
NJ Programming Best Practices
NJ-series Startup Guide
TF MC Extensions
User`s Manual - OEM International AB
MULTIPROG Programming Manual
Macintosh Setup Introduction Port Connection: Ethernet
EasyPAC
4 - SEW-Eurodrive
MOVI-PLC - Tecnica Industriale S.r.l.