Download POSQBi Instruction Guide

Transcript
Setup Process
POSQBi should be set-up to communicate properly with QuickBooks as well as to see if the necessary RMPOS files are available. Once communication has been established between the two software programs, you need to map the Restaurant Manager data to the appropriate account in
QuickBooks.
Setting up the interface (POSQBi) may be the most cumbersome portion when operating the interface but don’t be perturbed as once it is set-up, you may need to change the settings only when necessary.
The following steps below summarizes the setup procedure:
l
l
l
Getting QuickBooks and Restaurant Manager (POSQBi) to communicate.
Understanding the POSQBi interface
Mapping Sales, Tax, and Employee data from Restaurant Manager to QuickBooks
Establishing QuickBooks & Restaurant Manager Communications
Establishing communications between the two software programs is essential. The four steps
below will guide you through the initial setup process. Following these steps will make the transfer
of data a relatively seamless process.
l
l
l
l
RM BackOffice Setup- configure permissions to access the QuickBooks interface
Install Restaurant Manager POSQBi executable- POSQBi executable short cut installed on
the computer where QuickBooks resides, needed to open the form
Registering POSQBi with QuickBooks- allows the POSQBi to communicate with QuickBooks
Configuring Access to QuickBooks- grants access rights to QuickBooks and establishes certain communication parameters( i.e. employee data)
RM BackOffice Setup
You will be prompted to enter a password the first time you try to open the POSQBi interface. The
POSQBi interface is subject to the same password and security level parameters as any other Restaurant Manager program (i.e. Report Module). Therefore, you have to set the security level to
access the POSQBi interface in the station configuration (RM BackOffice Module) and configure
employees to have access to the POSQBi interface using security levels.
Employee access- It is recommended that you add any account or office manager in
the Employee Setup Form in the RM BackOffice Module. Give special consideration