Download Capitulo 1 - Stitch Era

Transcript
Creating Hotfix Designs
Direction line is not mandatory; you may enter it or not. In the last case, the system use an
internal and invisible, horizontal straight line. The Body tab of Flexible fill shows the following
properties:
Beads Spacing: Controls the space between beads along a row. A distance of 0
(zero) means that beads are “touching” its neighbours. If bead type is sequin, a
negative value, that produce some overlap, is allowed
Rows spacing: Controls the spacing between rows.
Margin: Set a distance from the borderline where no beads are placed
You can select the bead you will use with the control at the right of the Area Fill group. This control
always displays a real view of the bead type currently selected for the object.
Areas also let you change the fill mode on the fly. Pressing the control at the left of the group,
unfolds a menu with the available fill modes.
Areas with Hotfix Flat Fill
Hotfix Flat fill mode produces a regular, column by row based, beads placement. Better
suited for large or very geometric shapes, it does not require additional geometric
references and allows you to control column and row spacing, beads angle, etc.
Properties available in the Body tab for this fill mode are:
Columns spacing: controls horizontal beads separation
Rows spacing: controls vertical beads separation
Beads Offset: Sets an initial displacement for placement of beads in even rows.
Grid fill mode produces regular, vertically and horizontally aligned placement., but
sometimes, shapes require a bit irregular placement. Offset helps this avoiding
the vertical aligment. The value is a percentage. Best effect is obtained with 50%
offset.
4-9