Download CPU-1421 - UCL HEP Group

Transcript
MNL-0542-01 revA3
Note:
For further information about the watchdog programming, refer to “FDC 37B78x
Advance Information” manual from SMSC.
Watchdog time-out pin
For external control purposes, the status of the Watchdog timeout event is provided on connector J11 pin 9. This
signal goes high when the watchdog resets the system. The software can reset this signal by setting and
resetting bit 2 of the I/O port 110h. This signal is also initialized by hardware at power-on.
EXAMPLE: How to reset the watchdog time-out pin:
MOV
IN
DX, 110h
AL, DX
; Control Port
; Read actual value
OR
OUT
AL, 04h
DX, AL
; Mask reserved bits and set bit 2
; Write new value
AND
OUT
AL, FBh
DX, AL
; Mask reserved bits and reset bit 2
; Write new value
a Xilinx XC9572XL with the following characteristics:
Characteristic
Value
Recommended operation condition
Vomax = 3.3 V dc
DC characteristics:
Voh min= 2.4 V dc (test condition Ioh=-4 mA)
Vol max= 0.4 V dc (test condition Iol=8 mA)
The
signal
is
directl
y
conne
cted to
an
output
pin of