Download MOLCAS version 7.4

Transcript
SECTION 3. HOW TO RUN MOLCAS IN A NUTSHELL
16
3.5
Input Structure and EMIL Commands
MOLCAS has a modular program structure. The easiest way to run calculations is to prepare
an input file in which the different programs will be executed sequentially when the expression
&module is found. After such a label the keywords of the program, if needed, follow, one on
each line or separated by ;. Apart from the specific program input and keywords, MOLCAS
incorporates certain commands (see section on EMIL commands) that allow operations such
as to loop over the modules, restrict some of the executions, change variables or substitute
certain unix commands.
3.6
3.6.1
Basic Examples
A simple calculation on water
Start by preparing a file containing the cartesian coordinates of the molecule, in this case
water (this can be done by using any graphical interface program, for instance the MOLCAS
gv module, as shown later):
3
Angstrom
O
0.000000
H
0.758602
H
0.758602
0.000000 0.000000
0.000000 0.504284
0.000000 -0.504284
which we will name water.xyz. In the same directory we prepare the input for the MOLCAS
run. We can name it water.input:
&gateway
coord=water.xyz
basis=sto-3g
&seward
&scf
The module GATEWAY compiles the geometric parameters of the molecule (added from the
external file in this case) and the basis set definition. Module SEWARD computes the integrals
and identifies, if any, the molecular symmetry, and SCF computes the Hartee-Fock wave
function. For convenience just define:
export Project=water
and run the calculation, for instance:
molcas water.input -o water.out -e water.err
The file water.out contains now the output of the calculation and water.err the error
messages, if any. In the same directory we can find other files such as water.scf.molden
or water.grid (the last one only if you add at the end of the input the keyword grid it)
that will help to analyze the results graphically with the MOLCAS utility molcas gv (the
freeware program MOLDEN can also be used). We will see their use below.
In the case of an open-shell case we can do a UHF (or UDFT) calculation with the SCF
program or moving to the more powerful CASSCF approach. Below, we display two examples