Download CIMCO Edit v7 User Guide

Transcript
41
Modify Macro
Modify the selected macro.
To modify an NC code in an inserted macro (e.g. change the Z value of the macro
'Program Start/Program End' from 100 to 80 mm), highlight the NC code and click on
the Modify Macro icon . Enter the new Z value and then click OK.
NC Code selection in an inserted macro.
The Modify Macro dialog.
Find Macro
Click this icon to search for the specified macro.
You can search for a macro in an NC program in two ways:

In the field Cycles/Macros, select the macro to search for in the NC program
and click the button Find Macro.

Select the macro to search for from the drop-down list and click on the icon
Find Macro.
If you receive the message: Cannot find the macro ... , it is because the desired
macro was not specified as a macro. The NC text has been copied or created
manually.