Download seahub - Tritech
Transcript
Operator Manual SeaHub 7.1. Opening the SeaHub housing This procedure describes how to open the SeaHub units housing, for maintenance and hardware configuration procedures. DANGER! Before attempting this procedure ensure that the unit is disconnected from the AC and DC power source, and all other devices be disconnected from it. 1) Using a 2.5mm Hexagonal (Allen) Key to unscrew the two screws on the front panel of the unit (see figure below). NOTE The two hexagonal screws on the front of the panel are NOT held captive, and so should be removed and stored prior to continuing. 2) Remove the front panel assembly from the housing. 3) Remove the lid of the housing, by sliding it forward out of its guides. DANGER! The edges of the lid may be sharp – handle with care. 4) There is no need for further disassembly of the unit, as the circuit board and hardware jumpers are now visible. 5) To reassemble the unit, reverse the above steps. Issue 1 TIL – Eng – Spec – 080 Page 46 of 70