Download 2 - CyberMetrics

Transcript
78 Chapter 4: Gage R&R Entry
Appraiser Variation (AV)—Reproducibility
where n = # of parts, r = # of trials
Note: If a negative value results under the square root, the AV is reported as "0".%AV =(100 ×AV)
÷TOLRepeatability & Reproducibility (R&R)
2
2
(EV +AV )
R&R =
%R &R =(100 ×R&R ) ÷TOL
Ford Long Form Method
Equipment Variation (EV)—Repeatability
2
%EV =100 ×EV ÷R&R ×TOL
Appraiser Variation (AV)—Reproducibility
Repeatability & Reproducibility (R&R)
R&R =
2
2
(EV +AV )
%R&R =%EV +%AV
Linearity Study
To determine linearity, choose parts throughout the gage’s operating range. To find the bias of each part,
calculate the difference between the reference value and the observed average measurement. The slope of the
regression line that best fits the bias average versus reference values, multiplied by the process variation (or
the tolerance) of the parts, is an index that can represent the linearity of the gage. To convert gage linearity to a
percentage of process variation (or tolerance), multiply by 100 and divide by the process variation (or the
tolerance). As with stability, the recommended analysis technique is graphical–a scatter diagram with a best-fit
line.
You can use tool room or layout inspection equipment to determine the reference values of the parts. The
appraisers measure the parts, then the program calculates each part’s observed average. The difference
between the reference value and the observed average is the bias; the software calculates it for each part. The
linearity graph plots biases and reference values throughout the operating range. If the graph shows that a
straight line could represent the plotted points, then a best-fit linear regression line between biases and
reference values represents the linearity between those two parameters.