Download Touch Desk - AK Microsystems

Transcript
Note that it is not possible to do a single cycle in these cases if an APS
with ultrasound arrays is used for scoring, as TS2 is not directly connected
to the pinspotter and therefore has no control over the type of cycle.
The Auto Cycle on 10th frame and Auto Cycle on No-tap settings can be
changed for different bowling styles. For example, league bowlers may
expect the machine to cycle again, but open bowlers may not and regularly
hit the rakes. So these settings can be enabled for league styles but
disabled for open styles.
The Intelligent Pinspotter setting can also be enabled if the pinspotters
are NOT intelligent, but you do NOT want them to automatically cycle a
second time under any circumstances.

Cycle Delay. (Applies to TS MIU only) For non-intelligent pinspotters,
the scoring will cycle the pinspotters a second time to clear away the pins.
For APS systems, Cycle Delay is the delay in seconds from when the score
is taken, to when the machine will start its second cycle. For systems with
a camera, Cycle Delay is the delay in seconds from when the sweep
returns home to when the pinspotter will start its second cycle and should
normally be zero.

AMF Camera Delay(applies to TS MIU only) is the delay in 35mSec
(approximately 1/30th of a second) increments from when the sweep
switch is activated to when an AMF camera is triggered. Normally AMF
cameras have a suitable delay built in, so this setting can be 0. However if
the camera has been sourced from a different type of installation, it may
have a 0 delay and a suitable delay must be added here. For video type
cameras, see the Camera Tab

Dual CCD Cameras. Use this setting when dual CCD cameras are used
due to over lane ball returns for example. Applies to TS MI units only.

Ignore 2nd Ball signal. The pinspotter provides a 2nd Ball signal to the
scoring to indicate that it is in 2nd ball mode. Usually scores will only be
recorded when this signal matches the players current ball. For example, if
the player bowls the second ball of a frame, and the data received from the
pinspotter indicates it is still in 1st ball mode, then the score will not be
recorded. Setting this option causes TS3 to ignore the 2 nd ball signal, and
147