Download SpokePOV - Adafruit Learning System

Transcript
Once you connect, you can see the graphical interface for editing what image will be
displayed. The wheel panel shows a simulated image of what is in the SpokePOV.
The main controls for the SpokePOV are in a panel below the wheel panel. The three buttons
are used to 1) write the image currently in the wheel panel to the connected SpokePOV 2)
read the image currently in the connected SpokePOV into the wheel panel and 3) verify
that what's in the wheel panel is also what's in the SpokePOV.
There are also 3 controls up top, these are configurations for the entire SpokePOV. The
ro tatio n o ffset control allows you to change what the offset from 0 is. What this means is:
when you upload an image, you'll do it right side up. That means that the SpokePOV starts
displaying from the top, rotating clockwise. However, you're likely to put the magnet not at
12 o'clock but rather somewhere else, depending on whether you put the magnet on the
fork, or chainstay, etc. Here is a diagram of where these frame parts are
© Adafruit
Industries
https://learn.adafruit.com/spokepov
Page 55 of 82