Download the PDF

Transcript
UCLA iGEM
Why Iterative Capped Assembly?
UCLA iGEM is working on creating and expressing silk from customizable spider silk genes,
which contain many repetitive sequences assembled sequentially. We thought that ICA
would be perfect for our project because it allows us a high level of control over the construction of our silk genes.
Materials
UCLA iGEM
• Streptavidin-coated beads are essential for this method: they act as the solid substrate for
the elongating DNA chain. We used M-270 streptavidin coated Dynabeads from Invitrogen®.
• A highly selective DNA ligase is preferred, such as T7 DNA Ligase, since correct assembly
of the A, B and C monomers is critical. We used T7 DNA Ligase from NEB®.
• A type IIS restriction enzyme. We used BsaI from NEB®.
• Standard cloning materials are needed for upstream and downstream processing of parts.
We used Q5 HF DNA Polymerase for PCR, DH5a E. coli for plasmid amplification, oligos
and constructs from IDT and purification kits from Invitrogen®, Zymo® and Qiagen®.
Design considerations
Monomer ‘AB’
5’ AGTT ----3’ -----
Monomer ‘AB’
------ 3’
------ ACAG
5’ TGTC ----5’
3’ -----
------ 3’
------ GCAC
Monomer ‘CA’
5’ CGTG ----3’ ----5’
------ 3’
------ TCAA
Construct AB+BC+CA
5’ AGTT ----3’ -----
49
• The sticky ends that differentiate the A, B and C pieces must differ by at least two base
pairs (between the A, B and C pieces), and must not have GC residues on the ends of the
annealing region. Avoid more than 2-3 GC pairs in the sticky ends. The sequences we used
are shown in Figure 27.
------ TGTC ----- ------CGTG ----- ------ 3’
------ ACAG----- ------ GCAC----- ------TCAA
5’
Figure 27 - Diagram of individual ICA monomers with corresponding sticky ends. The monomers
are named after the sticky ends that they possess on the 5’- and 3’-ends, respectively. An assembled
3-mer construct is shown, but without the initiator, terminator or caps.
5’