Download 2015 MINI Hardtop
Transcript
Wheels and tires 45: aspect ratio in % R: radial tire code 17: rim diameter in inches MOBILITY All passenger car tires must conform to Federal Safety Requirements in addition to these grades. 84: load rating, not for ZR tires Treadwear F: speed rating, before the R on ZR tires The treadwear grade is a comparative rating based on the wear rate of the tire when tested under controlled conditions on a specified gov‐ ernment test course. For example, a tire graded 150 would wear one and one-half, 1 g, times as well on the government course as a tire graded 100. The relative performance of tires depends upon the actual conditions of their use, how‐ ever, and may depart significantly from the norm due to variations in driving habits, service practices and differences in road characteristics and climate. Speed letter T = up to 118 mph, 190 km/h H = up to 131 mph, 210 km/h V = up to 150 mph, 240 km/h W = up to 167 mph, 270 km/h Y = up to 186 mph, 300 km/h Tire Identification Number DOT code: DOT xxxx xxx 0115 xxxx: manufacturer code for the tire brand Traction xxx: tire size and tire design The traction grades, from highest to lowest, are AA, A, B, and C. 0115: tire age Tires with DOT codes meet the guidelines of the U.S. Department of Transportation. Tire age DOT … 0115: the tire was manufactured in the 1st week of 2015. Recommendation Regardless of wear and tear, replace tires at least every 6 years. Uniform Tire Quality Grading Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example: Treadwear 200; Traction AA; Temperature A DOT Quality Grades Treadwear Traction AA A B C Temperature A B C Those grades represent the tire's ability to stop on wet pavement as measured under control‐ led conditions on specified government test surfaces of asphalt and concrete. A tire marked C may have poor traction performance. The traction grade assigned to this tire is based on straight-ahead braking traction tests, and does not include acceleration, cornering, hy‐ droplaning, or peak traction characteristics. Temperature The temperature grades are A, the highest, B, and C, representing the tire's resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a specified indoor laboratory test wheel. Sustained high temperature can cause the ma‐ terial of the tire to degenerate and reduce tire life, and excessive temperature can lead to sudden tire failure. The grade C corresponds to a level of performance which all passenger car tires must meet under the Federal Motor Vehi‐ cle Safety Standard No. 109. Grades Band A represent higher levels of performance on the Online Edition for Part no. 01 40 2 961 140 - II/15 181