Download Dual Display Digital Multimeter
Transcript
DUAL DISPLAY DIGITAL MULTIMETER USER MANUAL DUAL DISPLAY DIGITAL MULTIMETER USER MANUAL 5. MEASUREMENT TUTORIAL 5-3. Resistance, capacitance, continuity beeper measurements 1). Press the button to select function. 2). Press [▲]or[▼]to the desired range. Press [AUTO/MAN] button 5-1. Voltage measurements (DCV, ACV, DCmV, ACmV) 1).Press the button to select desired function. 2).Press [▲]or[▼]to the desired range (if you have no idea about the value of input, we suggest you always start at the highest range). Press [AUTO/MAN] button for manual or auto-ranging selection. 3).Connect the test lead to the V and COM input terminals of the instrument. 4).Connect the test lead to the measuring points and read the displayed value. NOTE: After measuring high voltage to 1000V dc, errors may occur when the 100μV is measured. Allow up to one minute prior to making low-level measurements 5-2. Current measurements (DCA, DC 20A, ACA, AC 20A) 1).Press the button to select function. 2).Press [▲]or[▼]to the desired range (if you have no idea about the value of input. we suggest you always start at the highest range).Press [AUTO/MAN] button to change manual or auto-ranging. 3).Connect the test lead to the 2A or 20A and COM input terminals of the instrument. 4).Connect the test lead to the measuring points and read the displayed value. 15 to change manual or auto-ranging. 3). Connect the test lead to the Ω, and COM input terminals of the instrument. 4). Connect the test lead to the measuring points and read the displayed value. 5-4. Diode test measurements 1). Press the button to select function. 2). Connect the test lead to the and COM input terminals of the instrument. 3). Connect the test lead to the semiconductor junction (diode or transistor) as shown in Figure 5-1,and read the displayed value. z Figure 5-1 Connect to Connect to “ ” terminal. “COM” terminal 5-5. dBm measurements This function converts a voltage measurement into dBm. The function can be selected only when a voltage function (volts ac, volts dc, or volts ac+dc) is selected. Press [dBm] button, the secondary display shows the dBm value that reposed on the voltage value showed in the primary display. 16