Download Super Utility+ v.3 - Classic

Transcript
Page 84
Super Utility 3.0
DATA LOST
Data was lost during a read/write operation. Usually due to software problems, (the disk
transfer code of the program was not fast enough to keep up with the floppy disk
controller).
DRIVE DROPPED READY
A selected drive dropped its "ready" status bit before the I/O operation could be
completed.
DISK READ ERROR
An attempt to read a disk failed.
DISK WRITE ERROR
An attempt to write to a disk failed.
WRITE FAULT
Usually signals a hardware problem with the disk drive's write circuitry.
DATA LOST ON TRACK WRITE
While writing data to a track, the timing was off by a sufficient amount so that data was
lost before it could be written. This may happen if the TRS-80 CPU has been slowed
down.
nn SECTORS NOT COPIED
During a copy sectors operation, several sectors could not be read for some reason or
another. This message will usually appear in conjunction with some other error message
pinpointing the cause of the failure.
nn SECTORS NOT ZEROED
During a "Zero sectors" operation, several sectors could not be written to. Possible causes
are a hardware drive fault, or incompatible ("protected") formats on the target sectors.
nn SECTORS NOT LOADED
Several sectors could not be read. Possible causes are the same as above.
nn SECTORS NOT WRITTEN
Sectors could not be written during an I/O operation. This message will usually be
accompanied by other error messages pinpointing the cause.
ERROR ON TRACK WRITE
An error occurred during an attempt to write memory to a disk track. May indicate a
hardware problem.
TRACK READ ERROR
An error occurred during an attempt to read a track into memory.
Copyright © 1983 by Breeze/QSD, Inc.