Download CONTROL-M Job Parameter and Variable Reference Guide
Transcript
OS/390: AutoEdit Assignment (and both variable-name, and value) have the following characteristics: Length The total length of AutoEdit Assignment must not exceed 55 characters, including the %% prefix, variable-name, value, and the = sign. Case Sensitive Yes Invalid Characters Blanks AutoEdit Support Yes. An AutoEdit variable or expression can be specified as all or part of the value for this parameter. Related Parameters Do AutoEdit Indicates an AutoEdit expression that is dependent on how the job ended (OK or NOTOK) and can be used to influence other jobs, or subsequent runs of the current job. General Information AutoEdit variables are special variables that have a prefix of %%. They can be used to: • Pass parameters to, or influence the environment of a job when it is submitted. • Define variables to be used in Shout messages or in Do AutoEdit parameters when the job terminates. Parameters that Accept AutoEdit Variables AutoEdit variables can be specified as values for any of the following job processing parameters. These variables are resolved to actual values at time of job submission. • • • Command Do Mail (the To and Message fields) Do Shout (the Destination and Message fields) BMC Software, Inc., Confidential and Proprietary Information General Parameters 2-15
Related documents
CONTROL-M User Guide
AC Servo Drives Sigma-V Series USER`S MANUAL INDEXER Module
INCONTROL for z/OS 9.0.00 Administrator Guide
PZ4000 Power Analyzer Communication Interface USER`S MANUAL
SP, RSP, QRSP
Event24x7 User Manual
Sigma II Indexer User`s Manual
Fiche Pratique - Atelier Informatique Vidéo et Multimédia. Le site du
82-L0376 - DeWald hydraulic leveling systems w
Model No. 2MCE-24P Two Machine, Cuts Only
osimis-manual-4.0
ATLANTIC/PACIFIC