Download DUO

Transcript
"DUO" UNIT; INSTRUCTIONS USE AND MAINTENANCE HANDBOOK
Summary
CONNECT THE AMBIDEXTROUS UNIT TO THE CHAIR (Pict. D2)
Completely lower the chair using the two buttons (D1 and D2 – pict. D) and proceed as follows:
- thread the cables and the hydraulic/pneumatic connections of the unit inside the chair;
ATTENTION: the bundle of cables that comes out of the support (e) must pass over the cross member (m) that connects
the two rods.
- check the presence of the bearing and the thrust bearing ring (m) of the arm (i) in point (x), then bring the unit in to
align the pin (m) with the hole on the fixing plate (t), then slowly raise the chair to thread the pin in completely;
- thread the thrust bearing ring (z) (with an interior diameter of ∅i 47 mm) followed by the ball-support cage (v) and the
second thrust bearing ring (u) (with an interior diameter of ∅i 45 mm) onto the pin (m) and tighten the self-locking ring
nut (w); rotate the arm (i) until the piston pin is engaged (n) in the support seat (t) and then tighten the ring nut until it
abuts (w) using the wrench (y);
- before assembling the seat/backrest block ensure that the cable cover (j) is mounted correctly.
Pict. D2 – Connect the ambidextrous unit to the chair
Page 90