Download DL2e Data Logger Hardware Reference

Transcript
Appendices
Appendix C: Calculating the speed of data readings
NOTES:
[1] SCAN OVERHEADS is the time taken for the logger to prepare for taking readings
at the beginning of a LOG or EVENT, and performing ‘housekeeping’ calculations
when finished.
[2] The time required for an analogue reading depends on the magnitude of the input
signal. ‘Full scale’ is with respect to the voltage range being used. If autoranging, the
full scale figure applies for inputs of 4mV, 32mV, 262mV, 2.048V, and for
corresponding resistance values (Vin = R x Iexcitation).
[3] The timings quoted above apply for the 50/60 switch set to the European mains
frequency, 50Hz. When set to 60Hz, all analogue timings are approximately 20% faster
(see "Electrical mains environment" on page 48).
[4] Autoranging to a less sensitive range is slower than to a more sensitive range, and
requires an over-range recovery cycle in addition to the reading being taken.
[5] The logger takes separate autozero readings for each terminal group, for voltage and
resistance readings at each excitation current, as required for a LOG or EVENT. You
can minimise autozero overheads for mixed resistance readings by grouping channels
that use the same excitation current on consecutive input channels in the same terminal
group.
EXAMPLES: two autozero readings are required for channels 1 to 30 programmed as
VLT channels: 5 autozero readings are required for channels 1 to 6 programmed as
TM1, RR1, RR2, RR3, RR4, VLT, as in the DEFAULT configuration.
[6] The logger takes a single cold junction reading for any number of thermocouple
measurements in a single scan.
DL2e Hardware Reference
Page 151