Download MX-ONE System Description, Description

Transcript
ARCHITECTURE
6.1.9.4
Analog Trunk Units
Analog trunk units are provided with the TLU80 and TLU83 boards. The
TLU80 board provides analog E&M and inband tone signaling. The
TLU83 board provides analog loop and ground start signaling.
6.1.9.5
Digital Interfaces
The ELU33 provides 32 lines for digital extensions. It occupies 32
timeslots of the switch. The ELU33 can also handle enhanced signaling
on the extension line. Firmware download to both the board and to terminals connected to the extension lines is supported.
6.1.9.6
Digital Trunk Units
The digital trunk units are mainly intended for connection with PSTN and
PLMN networks but can also be used for private networking. The digital
trunks can be used for ISDN/QSIG, DPNSS, and CAS signaling. The
TLU76 board provides a single E1 (30B+D) interface, that can be used
for ISDN/QSIG, DPNSS, and CAS signaling. The TLU77 board provides
a single T1 (23B+D) interface, that can be used for ISDN, DPNSS, and
CAS signaling. The TLU79 board provides four ISDN-T Basic rate interfaces (2B+D). Media gateways with the MGU board have 8 built-in E1/T1
ISDN PRIs.
6.1.9.7
Tone Receiver/Sender and Conference Functions
The purpose of the tone receiver or sender function is to send out and
receive tone messages, such as dial tone, busy tone, congestion tone
and DTMF tones. The function is required for extensions, trunk calls and
conference calls. The TMU board is a mandatory board in all media gateways except EMG.
The TMU provides the function of tone/DTMF receiver, tone/DTMF
sender, and conference functions. The TMU can be initiated to handle
A-law or mu-law PCM. The SPU4 board is a board that provides the tone
receiver function, used for DTMF detection from mobile extensions.
MX-ONE Classic, equipped with LSU-E, which shall handle mobile
extension traffic, requires SPU4 boards, since all mobile extension calls
will request a DTMF receiver in SPU4 (instead of TMU). MX-ONE Lite
and MX-ONE Classic, equipped with MGU, have the DTMF receivers
built-in on the MGU.
MX-ONE Lite is delivered with a 'built-in' TMU. This TMU does not have
interfaces for external Music on Hold. To get Music on Hold in MX-ONE
Lite, functionality in MGU must be used, or additional TMU must be
inserted.
21/1551-ASP 113 01 Uen K3 2012-06-16
55