Download 5 - Deep!sonic

Transcript
Recording
T I P Don't overlook the "Wait for note" count-in setting. Using this with
"Click while recording" enabled causes Logic to start clicking but not start
recording until you play your first note. (i.e. you don't have to make it across
the studio to your keyboard by the end of the count-in.)
S e tting L o g ic' s Tem p o & T i m e S i gn a t u re
Logic's time signature (the number and type of beats per bar) can be set in the
Tempo/Signature Display of the Transport window. It can also be set directly on the
staff in the Score editor. The Transport window shows the time signature as a fraction "# / #".
Whenever you make a change to either the "numerator" (left # setting for the
number of beats per bar) or the "denominator" (right # - setting for the type of note
that is a beat), the new time signature takes effect at the closest barline to the left
of the Song Position. This will be indicated by a small time signature on the Bar Ruler
of any window that has a Bar Ruler such as the Arrange window, the Matrix editor,
etc. (The initial time signature — at beat 1 of bar 1 — is not shown on the Bar Ruler.)
To insert a new Time Signature
Using the Transport Window...
1. Set the Song Position to the position at which the Time Signature is to begin.
If there is to be only one Time Signature throughout the song, then go to the
first bar.
2. Adjust the time signature setting on the Transport panel
Click-drag on the numerator (top) and denominator (bottom) of the Time
Signature on the Transport panel to change the value
4
Logic Audio Guidebook
4 - 90