Download here - Voltsys.com

Transcript
Installation
Monitoring system via Radiomodule
5
The radiomodule card is an accessory used to replace the RS485 line
for data transmission to the monitoring device.
The radiomodule card is installed vertically on the communication card
09 by connecting the two a03 connectors. In turn, wiring ending with an
antenna installed outside the wiring box is connected to the radiomodule:
The part of the wiring box where the antenna will be installed will be in
place of one of the service cable glands 10 of size M20.
Monitoring is carried out using PVI-DESKTOP software.
Connection of the frequency input signal
Connect, through apposite cables, terminal blocks –WTACH and
+WTACH, found on terminal board a10, to the 25kW-WIND-INTERFACE terminal blocks labeled as “REF1” and “FC1“.
CARD
COM
CARD
a10
A2
RTD1 RTD2 RTD3
PT1000
RTD1 RTD2 RTD3
PT100
24V
GND
000279AG
A1
+WTACH
A1 A2
COM COM
-WTACH
J
- 45 -