Download Chapter 1: Hardware

Transcript
MPG LEVEL 2
There is nothing electrical involved in this device. When you roll the ball with your finger, the four small
wheels rotate. Only one wheel rotates if you rotate exactly in the plane of either the x or y-axis. If you
are rotating across the axis, then two of the wheels will be rotating. No matter what you do, you can
never get both wheels in the same axis to turn at the same time. This is the most magical part of the
device. Somehow they have designed and built the trackball so that the subtle pressure of your finger
pushing to rotate the ball in one direction on an axis is enough to engage one of the wheels and
disengage the other. All in all you have four input signals, one each for up, down, left and right. One
thing that was learned when first working with this device is that the mechanics are very sensitive, and
any attempt to make a solder connection to any part of the device destroyed it. This is why the trackball
is glued to the PCB and not soldered in any way.
To capture the motion electrically, a Hall Effect sensor is placed on the circuit board under each of the
wheels. There are a few tiny Hall Effect sensors that do the trick, and the one chosen for the course
board is from Panasonic, AN48841B.
Creating the schematic symbol and PCB land pattern for the whole trackball circuit was a tad tricky
because the manufacturer does not provide a datasheet. The center button was first tried in a way that
relied on the conductive actuator to close a circuit on the board with the outside metal of the switch as
a ground. As just pointed out however, attempting to solder to the trackball destroyed it.
Therefore, a small, ultra-low profile switch was specified to be placed underneath the trackball. The
button on this switch is actuated by the trackball. The schematic symbol and PCB land patter are shown
in Figure 1.3.5.3.
notes_mpgl2_chapter1.docx
Version 1.1
Page 25 of 37