Download Users Guide_LMX

Transcript
U S I N G
d.
e.
T H E
L A S E R B O X X
P L U G & P L A Y
V E R S I O N
Once the “STATUS” LED stops blinking and becomes solid green, the LaserBoxx is in stable operation
mode;
The laser head shutter may now be opened by moving the mechanical slide switch above the
assembly into the “OPEN” position.
2.4.1 Turning off the LaserBoxx LMX
a.
b.
c.
d.
Close the laser head shutter;
Turn the key switch (E3) into “OFF” position;
Turn the POWER switch (E2) into “0” position;
Unplug the heatsink power supply cord.
2.4.2 Description of status LEDs
Laser emission is indicated by a white LED placed immediately next to the emission switch. Its purpose is to
warn the user whether the laser emission is occurring or not. Its behavior comply with CDRH laser safety
recommendations.
LED status
Corresponding status
Solid white
Laser emission is activated
Off
Laser emission is desactivated
The operational status of the laser is indicated by the “STATUS” LED on the front panel of the controler.
Detailed status information is gathered in the following table:
LED status
Corresponding laser status
Possible actions
Solid orange
The electronic controller is powered-up
while the laser emission is disabled
The laser is ready to be started.
You can turn the key swich to “ON” or
send a command to start up the laser.
Blinking green
The laser module is in boot sequence
Wait for completion of the boot sequence.
Solid green
The laser module is stabilised
The LaserBoxx is stabilized and ready to
emit.
Blinking orange
and green
Wait for the laser to reach stabilty.
Blinking red
The laser emission has become
unstable and the embedded software
searches for optimal operational
parameters
Warning raised
Solid red
Alarm raised
20
The LaserBoxx continues to operate but it
is stongly recommended that the cause of
the warning be found and removed (see
section 8.1.1)
The emission of the LaserBoxx is
automaticaly stopped (see section 8.1.1)