Download MX Series Reference Manual

Transcript
Item
ETHERNET PORT
Function
DISABLE — Disable the Ethernet or set your connection via
Ethernet DHCP or Static Ethernet.
DHCP — To set up DHCP to send a broadcast to the network
to allow a dynamic IP address to be set, tap the DHCP check
box. The unit must be restarted for the change to take effect.
STATIC — To set up Static Ethernet connection, enter the IP
address, Internet mask, Gateway, and DNS settings by tapping
the appropriate buttons.
NOTE: The MX Series terminal must be restarted to apply the
Ethernet configuration.
ECR PORT
The current status of your ECR setting is displayed.
TAILGATE — Configure the ECR Tailgate Address by tapping
the button beside the numbered slot, then tap the right arrow to
enter the lane number. Press the ENTER key.
FEATURE C — Set up connection options for Feature C by
tapping the Port, Character Size, Parity, and Stop Bits. Tap the
right arrow to continue. Select the Baud Rate and Flow
Control. Tap the right arrow and enter the Lane Number. Press
the ENTER key.
Press the CLEAR key to return to the Configure ECR screen.
UNCONFIGURE — Tap to remove ECR Port configuration.
USB PORT
The USB PORT menu varies depending on the cable
connected. Some cables support USB Host, while others
support USB Device.
USB HOST — The menu allows the selection of the USB Host
Mode. Valid options are Cable Detect (default) and Disabled.
Cable detect allows plug and play with supported devices.
Disabled causes the terminal to ignore an attached USB
device.
USB DEVICE — The menu allows the selection of the USB
Device Mode. Valid options are disabled (default) or Serial Port
(COM5). Selecting Serial Port (COM5) and rebooting causes
the terminal to emulate a serial port.
NOTE: The options Ethernet Adaptor and Mass Storage are
currently not available.
PAYWARE
SET ADDRESS — Enter the server address.
SET NAME — Enter the name.
SET PORT — Enter the port address.
ENABLE PAYWARE — Tap to enable PAYware on next boot up.
START PAYWARE — Tap to start PAYware immediately.
MX SERIES REFERENCE MANUAL
35