Download GTSTRUDL Version 32

Transcript
GT STRUDL
DESIGN SLAB Command
Cut 2-2:
The cross-section Cut 2-2 is defined along the center line in the middle region of the slab
strip and represents the maximum “positive moment” section in the slab where bottom
reinforcing steel would be required. Cut 2-2 originates at node #166 and terminates at node
#176. The elements along Cut 2-2 are elements #141-#150 on one side and #151-#160 on
the other side. The command given for Cut 2-2 Case 1 is:
“DESIGN SLAB WOOD AND ARMER JOI 166 176 ELE 141 TABLE UNESCO
BOTTOM SPACING 10 OUTER LAYER"
In this case, the user requests that a slab cross-section beginning at node #166, ending at
node #176, and in the plane of element #141 be reinforced according to the average effect
produced by the Wood and Armer method. The user has specified that UNESCO metric
reinforcing bars are to be used. The bottom reinforcement spacing has been constrained to
10 inches, and the reinforcement to be designed is located in the outer layer. The results of
the DESIGN SLAB command are shown in the following table:
Calculation
Surface
Bar
Spacing Area Prov. Moment Strength
Moment Required
#
in
sq. in.
lb-in
lb-in
DESIGN SLAB Bottom
M14
10.0
2.864
1664920.7
671358.2
DESIGN SLAB
NA
NA
NA
NA
NA
Top
5.2 - 15