Download ARKEIA 5 COMMAND LINE INTERFACE MANUAL

Transcript
•
comment(Optional)
This parameter is used to assign a descriptive comment to the tape drive
being created. This comment can be useful to display additional information
related to the tape drive, as, for instance, its location, purpose, etc. The correct syntax for this parameter is:
comment=[DLT tape drive for CAD machines]
Drive deletion
Deleting a drive allows the system administrator to quickly reconfigure Arkeia, in
the case maintenance or replacement is needed for a hardware unit.
The correct syntax to delete a drive is the following one:
arkc -drive -delete -[D|I] <parameters...>
Where the parameters can be the following ones:
•
name(Required)
The name parameter should contain the name of the drive to be deleted. For
instance:
arkc -drive -delete -D name=DLT02
A list of all the tape drives available on a given Arkeia server can be obtained
with the command:
arkc -drive -list
•
drvid(Optional)
The drvid parameter
is the ID assigned to the tape drive when it was created
by Arkeia. This ID value can be used instead of the name parameter described
above. For instance, the two commands below are equivalent, assuming that
3bc419cd is the correct ID of the tape drive named DLT02:
arkc -pool -delete -D name=DLT02
arkc -pool -delete -D plid=3bc419cd
Drive modification
To modify a tape drive characteristics, the syntax of arkc is the following:
arkc -drive -modify -[D|I<input file>] <parameters...>
To modify a tape drive, it is necessary to supply to arkc its name or its drvid. For
more information on this parameter, please refer to The create command of arkc on
page 15. To obtain a list of the names of the available tape drives, it is always possible to enter the following command:
arkc -drive -list
102
Arkeia 5 User Manual