Download SS6000 Soft Starter User Manual

Transcript
Introduction
Receiving:
Inspect the Smartstart®6000 for any shipping damage. If any damage is found, report it to the carrier immediately. Remove cover of starter and visually check for damage. Do not attempt to operate the Smartstart®6000 if any obvious damage exists or suspect damage has occurred. After the initial inspection, the Smartstart®6000 can be repacked and stored in a clean, dry location until it is required for use. Handling&Storage:
To ensure the starter is protected before installation, handle and store the equipment in its packaging. DO NOT store this equipment in an area where the ambient temperature will fall below ‐20ºC or rise above 70ºC. DO NOT store this equipment in areas that are subject to condensation or corrosive atmosphere. Proper storage is necessary to ensure satisfactory startup and performance. HandlingonInstallation:
The Smartstart®6000 range comprises 5 sizes with various weights and dimensions. An appropriate handling device must be used with large starters. ‘Handling points’ have been provided to aid lifting. The precautions described below must be followed: Use handling points where provided to lift larger units. Software:
This manual applies to the Smartstart®6000 series software revision V1.20. The Software revision can be viewed on the ‘Dash Board’ (Display) of the Starter. DO NOT handle the starter by the power terminals/busbar. Technical Manual: Smartstart® 6000 IMI0042 rev H Page 2