Download PowerFlex 700 Drive - Frame 7 Components Replacement
Transcript
Chapter 3 Component Replacement Procedures 12. Remove the Converter Bus Bars (DC+ and DC–). DC– DC+ DC Choke Connectors Snubber Board Mounting Bracket Converter Bus Bars SCR module 13. Disconnect the SCR gate leads. 14. Remove the four (4) Phillips screws that hold each SCR to the Heatsink. 15. Remove the SCR modules. Install Components 1. Using isopropyl alcohol, thoroughly clean the surface of the Heatsink. 2. Verify that the mounting surface of each new SCR module is clean. If not, clean with isopropyl alcohol. 3. Using a 3" putty knife or similar tool, apply a thin even coating of the supplied thermal grease to the mounting surface of each SCR module. Use enough thermal grease to create a conductive coating, but not so much that the two surfaces can rock. Important: In the next step, take care to not disturb any of the thermal grease on the SCR module. 4. Install each new SCR module with supplied screws and tighten using this torque sequence: ➊ SCR Torque SCR Torque First Sequence: 0.7 N-m (6.0 lb.-in.) Final Sequence: 5.6 N-m (50 lb.-in.) ➍ 52 ➌ ➋ Rockwell Automation Publication 20B-IN017B-EN-P - September 2011 ➍ ➋ ➊ ➌