Download chapter 1 specifications

Transcript
Disassembly, Reassembly and Lubrication
3-6-11. “Unit, Control Panel”, “SA PNE Sensor”, “SA, Relay PCB” and
“SA, Main PCB”
(1) Unit, Control Panel
1. Remove the “Case U”. Refer to “3-6-3(1) Removing the “Case U” Block”.
3. Remove the “Unit, Control Panel” upwardly by releasing the hooks (2 pcs.).
4. Remove the “Cushion, Ope-Pane Cable” and disconnect the “Cable, Opepane” from the
“Unit, Control Panel” ().
Note on reassembling:
• When connecting the flexible cable, be sure that the insertion direction is correct. If you
insert it reversely, circuit is not electrically connected. (Its foil side faces to the right.)
(2) SA PNE Sensor
1. Disconnect the connector (J12), remove the 1 screw (BH, M3x4 (NI)), and detach the “SA
PNE Sensor” Block.
2. Remove the 2 screws (PH, M2x4) and detach the “SA PNE Sensor” () from the “Holder
PNE”.
BH, M3x4 (NI)
BH, M3x4 (NI)
SA PNE Sensor
BH, M3x4 (NI)
PH, M2x4
Spacer PNE
BH, M3x4 (NI)
Holder PNE
PHT
(#2), M3x6
J12
Cover Main PCB
"Plate Main PCB"
Block
Cable, Opepane
BH, M3x4 (NI)
Cushion, Ope-Pane Cable
Unit, Control Panel
J4
J15
Wire Tie
SA Power Cable
3-27
CL-S6621