Download About the BV Libra

Transcript
Making vascular images
5.11
Making vascular images
5.11
• Vascular imaging is only possible when the ‘Vascu’ examination type is selected. See
N OT E S
section 5.5 ‘Entering patient and examination data’.
• Switching between subtraction and normal fluoroscopy is possible by means of the
foot switch.
Performing subtraction
5.11.1
1
Press the middle pedal [43] of the foot switch to toggle to the ‘Subtr’ mode.
The mode is displayed in the lower-right corner of the monitor.
Tips
Storage frequency
To change the storage frequency, press the ‘Store’ soft-keys [20].
Image storage
Use HDF to store the subtracted run.
Blurred images
Do not move the system or patient during the subtraction procedure.
This will result in blurred images.
2
Press either the right key [40] on the hand switch or the right pedal [42] of
the foot switch.
Do not release the hand/foot switch until the subtraction run is completely finished.
When the hand/foot switch is released, a new mask is made immediately after
performing fluoroscopy again.
N OT E
After completion of the mask, the image is turned to grey and the message
‘Inject’ appears on the monitor.
3
Start injecting the contrast medium.
Images of the contrast bolus will appear on the monitor.
Release the hand switch key [40] or the foot switch pedal [42] as soon as the
contrast bolus has faded away.
5
To check the acquired images dynamically, press the |Run cycle| key [25].
6
To view individual images of the run, press the |Run cycle| key [25] again
and use the |Previous image/run| key [33] or the |Next image/run| key [33].
1
1
36260045
9896 001 92274
36260043
4
Tips
Philips Medical Systems
Making corrections
To make corrections on a subtraction run, see section 5.11.2
‘Remasking’.
BV Libra
Release 1.2
Operation
5-31