Download Tempus LX GPS - EndRun Technologies

Transcript
CHAPTER FIVE
Display and Keypad
Operation
The display is organized like the inverted tree structure shown below:
Time / Status
Display
Main Menu
Receiver
Clock
Opt-I/O
Display
Faults
Display
Intensity /
ScreenSave
System
Fault
Status
Clock Menu
Time-Mode Loc-Offset Hrs-Disp
Time
Mode
Setup
Local
Offset
Setup
Hours
Display
Format
Network
NTP
Network
Address
Setup
Firmware
Program
Revision
Option I/O Menu
DST
CPU-I/O
Slot1
Plug-in
Option
Info/Setup
Contact
Information
NTP Menu
OptCard1 OptCard2 OptCard3 OptCard4 OptCard5
Daylight
Savings
Setup
About
Slot2
Plug-in
Option
Info/Setup
Slot3
Slot4
Slot5
Plug-in
Plug-in
Plug-in
Option
Option
Option
Info/Setup Info/Setup Info/Setup
Status
NTP
Operation
Status
Setup
Broadcast
Multicast
Setup
CPU Module I/O Menu
PPS-Setup
1PPS
Pulse
Width
Code-Out
ProgTTL
Syntheszr
Time Code
Output
Format
Prog TTL
Output
Selection
Synthesizer
Rate
Selection
SerTimeOut
Serial
Time
Format
Receiver Menu
Status
GPS
Receiver
Status
Ref-Pos
GPS Mode
Reference
Position
GPS
Dynamic
Mode
Osc-Stat
Oscillator
Status
AntFltMask
Antenna
Fault
Mask
SigFltMask
Signal
Fault
Mask
Traversing the Display Structure
After power initialization the welcome message will appear. Press any key to go to the Time/Status
display, which is described under the heading Detailed Display Descriptions. From the Time/Status display, press ENTER (or DOWN arrow) to go to the Main Menu. As illustrated in the diagram
above, several status and setup displays are accessible from the Main Menu. To traverse downward
through the tree use the RIGHT and LEFT arrow keys to highlight a selection and then press ENTER.
To traverse back up the tree press BACK (or UP arrow) to return to the previous display.
Editing
To modify a parameter, traverse to the appropriate display and push EDIT. This will cause the edit
display to appear. Within the edit display, the modifiable parameter value is highlighted. Use UP and
DOWN to scroll through all the possible parameter values. When editing a sequence of numbers,
use LEFT and RIGHT to select other digits. When the parameter is correct, press ENTER to load the
new value. All entered values are stored in non-volatile FLASH and restored after a power cycle. If
you wish to abort the edit process, press BACK. This operation returns you to the previous display
and the parameter will remain unchanged.
34
Te m p u s L X G P S U s e r M a n u a l