Download Oasys 12.1 Release Notes

Transcript
Oasys Ltd LS-DYNA Environment Software

Release Notes
Version 12.1
Case 23986
When playing a macro with Pause commands 'Button box not yet defined' error messages were
occasionally shown. This has been fixed.
Mass

Case 25392
The count and mass of included part/nrb _inertia displayed on the assign mass panel was
incorrect if sub-group massing was in use, though the calculation was itself correct. Now fixed.

Case 25089
When using the 'mass prop' feature, it was possible to get the wrong answer when selecting
*ELEMENT_MASS elements. This has been corrected.

Case 24551
Selection of an include file in the mass property calculator resulted in inclusion of any lumped
mass on the nodes of the include, irrespective of whether or not the element from which the mass
derived is in the selected include. This has been fixed so that, unless the option is set to include
attached mass on elements, mass derived from elements outside the selected include will be
excluded.
Materials

Case 25347
PRIMER could crash if importing a material to a material edit panel, and the 'Filter' option is
used. The crash would only occur if clicking on the 'Filter' button before typing in the filter
string. Now fixed.

Case 24487
Fixed: The field SBUCK for MAT_203 has a default and therefore zero value is now allowed.

Case 22284
Fixed the units of fields & of MAT 196.
Mechanism

Case 24871
Mechanisms in PRIMER provide several ways of 'driving' motion, and one of these is to define a
new angle for a HINGE or LINE joint. The mechanism positioner will rotate the attached
assemblies to achieve the desired angle.
In a few cases the direction of rotation went the 'wrong' way, in the sense that if clockwise
rotation was requested what was actually produced was anti-clockwise motion.
This was due to an error in calculating what constitutes positive motion of a body about a vector:
the existing algorithm could fail in cases where the orientation of the bodies was not wellconditioned.
The correct calculation method has been substituted and rotation should now take place reliably
in the requested direction.
Ove Arup and Partners Limited | May | 2015
Page 20