Download SURVEY PRO TM - Hayeshelp.com
Transcript
GPS Coordinates in Survey Pro coordinates to your mapping plane coordinates. Therefore, a localization is not required in this case. • If your job already contains geodetic coordinates which were measured from an autonomous setup, and you are continuing the survey using coordinates from the network GPS, you will need to resolve the localization to get results in the proper local system. This is the case for both Ground – TDS Localization and Mapping Plane horizontal projection mode. • If your job already contains geodetic coordinates which were measured from an initial accurate base setup, then you can continue to survey using the network GPS coordinates. This is only the case when the initial accurate base setup and the network GPS coordinates are in a consistent coordinate system. The network GPS server operator should be able to tell you what coordinate system and datum the network coordinates are surveyed in. Note: The guidelines above assume that all of the receivers in the network GPS have coordinates that are accurate with respect to each other. This is usually the case, especially for any networks that support VRS or some other networked RTK service. However, it is possible that the base stations in a network have not been accurately tied to each other. In this case, the geodetic coordinates from one base may not match the geodetic coordinates from another base. The network GPS server operator should be able to specify the accuracy of the different stations with respect to each other. 213