Download Train Dispatcher 3 M.. - Train Dispatcher Simulation

Transcript
Train Dispatcher 3
Figure 34 - Random Defect Detector Parameters Dialog
For each type of wayside defect detector the user can define a range of randomness for alarms and false alarms. The
following describes each of the fields in the Random Defect Detector Parameters dialog:
♦
Alarms - A number of track blocks may contain wayside defect detectors. Trains passing through these blocks
will be scanned for problems and an alarm will be generated if a problem is detected. This parameter
determines the number of times a problem be detected for every 1000 trains scanned. If an alarm is
generated the crew will stop the train, walk to the car that is the subject of the alarm, and determine if the
alarm was real or false. This process will cause the train to be stopped for a period of time based on the
distance from the front of the train to the car that caused the alarm.
♦
False Alarms - Not all alarms are real. A number of them are false. This parameter sets the percentage of
alarms that are false. If the alarm is false, the train will restart immediately after the car is checked. If the
alarm is real, the train will be stopped for an additional period of time while the crew corrects the problem.
8.1.3. Random Switch and Signal Failure Parameters
To enter the switch and signal failure parameters for the random performance generator, select the “Random Switch
and Signal Failure Parameters” item under the “Random” menu. Figure 35 will appear.
Page 35
6 December, 2000