Download PSM3750 - NumetriQ
Transcript
PSM3750 user manual 15 Harmonic analyser The NumetriQ harmonic analyser computes multiple DFTs on the input waveforms in real time (refer to the chapter on frequency response analysis for the formulae for DFT analysis). There are three modes of operation: single harmonic, difference thd, and series thd. In single harmonic mode, the specified harmonic is displayed both in Volts and as a ratio to the fundamental; in either thd mode, the computed thd and a specified harmonic are displayed as a ratio to the fundamental. In difference thd mode, the thd is computed from the rms and fundamental: thd = 1/h1 √ ( rms² - h1²) In series thd mode, the thd is computed from a series of up to 64 harmonics. i=n thd = 1/h1 √ ∑ i=2 hi² where hi is the ith harmonic In series mode the magnitude and phase of all the harmonics can be seen as a table or the magnitudes can be displayed as a bargraph which changes in real time with the measurements. When viewing the bargraph, ZOOM+ and ZOOM- change the vertical axis by a factor of 10. In all cases the harmonics are phase referred to CH1 fundamental so that their in-phase and quadrature components may be separately filtered to minimise noise. 15-1