Download Bigsteps user Manual - Winsteps and Facets Rasch Analysis Software
Transcript
+-----------------------------------+----------+----------+-----+------------------------+
NUM is the sequence number of the person, or item, in your data, and is the reference number used for
deletion or anchoring.
NAME is the item name or person-id.
SCORE is the raw score corresponding to the parameter.
COUNT is the number of valid data points.
MEASURE is the estimate for the parameter. If the score is extreme, a value is estimated, but as
MAXIMUM (perfect score) or MINIMUM (zero score). No measure is reported if the element is
DROPPED (no valid observations remaining) or DELETED (you deleted the person or item).
§ If unexpected results are reported, check whether TARGET= or CUTLO= or
CUTHI= are specified.
ERROR is the standard error of the estimate. For anchored values, an “A” is shown on the listing and the
error reported is that which would have been obtained if the value had been estimated.
INFIT is a standardized information-weighted mean square statistic, which is more sensitive to unexpected
behavior affecting responses to items near the person's ability level.
MNSQ is the mean-square infit statistic, with expectation 1. Values substantially less than 1
indicate dependency in your data; values substantially greater than 1 indicate noise. See p. 113.
ZSTD is the infit mean-square fit statistic standardized to approximate a theoretical mean 0 and
variance 1 distribution. When LOCAL=Y, then EMP is shown, indicating a local {0,1}
standardization. When LOCAL=LOG, then LOG is shown, and the logarithms of the mean-squares
are reported.
OUTFIT is a standardized outlier-sensitive mean square fit statistic, more sensitive to unexpected behavior
by persons on items far from the person's ability level.
MNSQ is the mean-square outfit statistic, with expectation 1. Values substantially less than 1
indicate dependency in your data; values substantially greater than 1 indicate the presence of
unexpected outliers. See p. 113.
ZSTD is the infit mean-square fit statistic standardized to approximate a theoretical mean 0 and
variance 1 distribution. When LOCAL=Y, then EMP is shown, indicating a local {0,1}
standardization. When LOCAL=L, then LOG is shown, and the logarithms of the mean-squares are
reported.
PTBIS is the point-biserial correlation, rpbis, between the individual item (or person) response “scores” and
the total person (or item) test score (less the individual response “scores”). Extreme scores are
omitted from the computation. Negative values for items often indicate mis-scoring, or rating scale
items with reversed direction. Letters indicating the identity of persons or items appearing on the fit
plots appear under PTBIS. For adaptive tests, an rpbis near zero is expected.
The formula for this product-moment correlation coefficient is:
r pbis =
∑(x - x )(y - y )
2
2
∑ (x - x ) ∑ (y - y )
where x = observation for this item (or person), y = total score for person omitting this item (or for
item omitting this person).
Conventional computation of rpbis includes persons with extreme scores. These correlation can be
Page 98
A User's Guide to BIGSTEPS