Download Megagen DPR45

Transcript
RENTAL SERIES ELECTRICAL GENERATOR
4 STARTING AND STOPPING THE UNIT
To start up the Electrical Generator, follow the steps listed below:
1)
Check the levels of oil, coolant and fuel.
2)
Close the battery isolator.
3)
Release the emergency shutoff switch if it has been pressed.
4)
Check the Electrical Generator’s automatic switch (levers should be in the
lowered position).
5)
To perform the startup of your Electrical Generator, please refer to point 6
- OPERATION MANUAL, taking into account the control panel model of your
unit.
6)
Once the unit has been started, connect the Electrical Generator’s
automatic switch.
7)
Make sure the earth leakage circuit breaker (ELCB) is functioning properly
by pressing the TEST button.
8)
Turn on the electromagnetic circuit breaker once again and use the
Electrical Generator normally.
To stop the unit:
1)
Disconnect the loads.
2)
Turn off the electromagnetic circuit breaker.
3)
Leave the engine running at no load for 2 minutes to cool down the
generator unit.
4)
Stop the Engine completely by switching the control module switch to the
OFF position.
USERS MANUAL
Page 18 of 62