Download how to use ddr sdram um - Electrical and Computer Engineering

Transcript
CHAPTER 9 DATA STROBE SIGNAL (DQS) CONTROL OPERATION
9.1.1 Data strobe signal (DQS) in read cycle
In the read cycle, DDR SDRAM drives the data strobe signal (DQS), which is in synchronization with the clock
(CK). The receiver captures the data (DQ) using DQS as a timing reference.
The operation of DQS in the read cycle is as follows.
(1) High impedance while data is not output (<1> in figure).
(2) After read command (READ) input, DQS changes to low level approximately 1 clock prior to data output (<2> in
figure).
(3) DQS starts toggling at the same frequency as the clock (CK) (<3> in figure).
(4) DQS toggling continues until the burst read operation is completed.
When the burst read operation is
completed, DQS changes back to high impedance (<4> in figure).
Figure 9-2 shows the operation timing of DQS for the read cycle.
Figure 9-2. Data Strobe Signal in Read Cycle
CL = 2, BL = 2
T0
T1
T2
T3
T4
T5
/CK
CK
Command
READ
<1>
DQS
<2>
Hi-Z
DQ
Remark
66
<4>
<3>
Hi-Z
Q0
CL: /CAS latency, BL: Burst length
User’s Manual E0234E30 (Ver.3.0)
Q1
Hi-Z