Download M-230 Linear Actuators

Transcript
5 Installation
5.4 Installing the Actuator in a Mechanical Mounting
NOTICE
Incorrect tightening torque of the mounting nut!
The motion of the pusher can be hindered by a mounting nut that has been tightened
too strongly. This reduces the positioning accuracy.

Tighten the mounting nut to a maximum torque of 1.7 Nm.
INFORMATION
To achieve an optimum repeatability, the mounting shaft must not have any
backlash.

During mounting, make sure that there is a faultless connection between the
actuator and the mechanical mounting.
Figure 7: Clamp connection (schematic)
M-230 Linear Actuators
1
Mechanical mounting
2
Sleeve
3
Mounting nut, 3/8 inch
4
Mounting shaft with thread
5
Pusher with end piece (flat)
MP102E
Version: 1.1.0
23