Download Foreword - Farnell

Transcript
Text-based presentation and maneuvering
7.3 Maneuvering Textblocks
Text blocks consist of text lines with static and dynamic objects. The dynamic objects show the current status for those signals to which the object
is linked. Certain dynamic objects are maneuverable which means that
you can change their status and values in run-time mode.
To alter a maneuverable object you use the arrow keys to move the cursor
to the right position so that the object is marked. Textblocks can be scrolled
vertically but not horizontally
Digital objects
Digital objects are maneuvered by marking the required object. Then
press [ENTER] to alter the status of the object.
Analog objects
Analog and Date/Time
The objects are maneuvered by placing the cursor on the right object. After
this the new value is written in. Finish with [ENTER].
Before [ENTER] is pressed, new value entry can be aborted by leaving the
field with [↑] or [↓]. The old value will then be retained.
Text objects
Not valid in E100.
Maneuver a text object by moving to the object and pressing [ENTER].
Then an entry field is shown. The entry field is either on the first or last
line depending where the object is on the display. Scrolling of the entry
field takes place if the text is longer than the width of the display. Press
[ENTER] when writing is complete.
Message objects
Maneuver a message object by moving to the object with the arrow keys
and press [ENTER]. An option list is now shown with all maneuverable
states on the display. Move to the required state, press [ENTER] and the
analog signal linked to this state is forcibly set.
7-11