Download Multi Function Controller User`s Manual
Transcript
Multi Function Controller Precautions | User Guidance Information | Specification | MF-Controller Installation How to use Remote Controller The number of MPDP unit can be selected up to 10 units horizontally. The initial setting is 3 units. Following description shows how to configure 4 MPDP units. POWER ON POWER OFF COMMAND INPUT SELECT PC DVI DTV BROAD CAST DVD VIDEO S-VIDEO NORMAL The number of MPDP unit can be selected up to 10 units vertically. The initial setting is 3 units. Following description shows how to configure 4 MPDP units. POWER ON POWER OFF COMMAND INPUT SELECT PC DVI DTV BROAD CAST DVD VIDEO S-VIDEO NORMAL 1.Start with press "GO" button. 5. Start with press "GO" button. 2.Press "LEFT" and "RIGHT" buttons to begin horizontal configuration. (◀ ▶) 6. Press "UP" and "DOWN" buttons to begin vertical configuration.(▲▼) Enter Enter GO AUTO S1 S2 S3 S4 S5 S6 S7 SCR R G B W Horizontal configuration configuration 3 LEDs from the right are on, because the initial setting is 3 MPDP units. TEST PATTERN 3. In case the number of horizontal MPDP units is 4, press MPDP The same numbers of LEDs are turned on. S1 1 S5 5 2 S2 PDP S3 REMOTE CONTROL S6 R S7 6 G B 9 POWER ON 3 7 S4 S1 1 SCR 8 S5 5 configuration COMMAND DVI DTV BROAD CAST DVD VIDEO S-VIDEO NORMAL S4 S5 S6 S7 SCR R G B W 2 S2 PDP S3 REMOTE CONTROL S6 R W POWER OFF PC S3 Vertical configuration 7. In case the number of horizontal MPDP units is 4, press MPDP The same numbers of LEDs are turned on. heck LED whether they are turned on as many as the selected MPDP units. C (4 LEDs from the right) INPUT SELECT S2 4. Press "GO" button to finish configuration mode. The LED will turn to previous indication after sending configuration to MPDP. configuration 3 LEDs from the right are on, because the initial setting is 3 MPDP units. 4 S4 S1 TEST PATTERN button. Horizontal configuration 0 GO AUTO S7 6 G 9 B 7 S4 button. 4 SCR 8 W Vertical configuration 0 POWER OFF POWER ON 3 S4 configuration Check LED whether they are turned on as many as the selected MPDP units. (4 LEDs from the right) COMMAND INPUT SELECT PC DVI DTV BROAD CAST DVD VIDEO S-VIDEO NORMAL 8. P ress "GO" button to finish configuration mode. The LED will turn to previous indication after sending configuration to MPDP. Enter Enter S1 S2 S3 S4 Horizontal configuration S6 S7 ※ You can S5continue to SCR vertical configuration without finish the mode. R GO AUTO GO AUTO G B TEST PATTERN 14 | ORION PDP CO., LTD. W configuration S1 S2 S3 S4 S5 S6 S7 SCR R G B W configuration 9.The rightmost LED (T.P.) is turned on when MF Controller starts BIC communication. If this LED blinks, there are some communication errors. LED is turned off after the communication.MPDP TEST PATTERN ORION PDP CO., LTD. | 15 MPDP PDP Vertical configuration PDP REMOTE CONTROL