Download TRANSIT MANUAL

Transcript
APPENDIX I—New 800MHz BART Radio System
(2). If you want to ramp the system choices up or down, press the
GROUP/SEL RAMP CONTROL + or - while the system name is
displayed. A tone sounds each time a system name changes.
C. The MDX radio can be programmed with several systems in it. A system in the
radio is like a page in a book. Radio channels or talkgroups are like lines on the
page (system). Each system can have up to 16 talkgroups or channels in it. In
order to communicate with others, the radio user must know the talkgroup or
channel to be used and the system it is found in. San Francisco Fire Department
primary tactical channel is System 1, Talkgroup 1. The radio operator selects the
proper system and then the proper group or channel within the system and
communication is established.
D. Trunked radio talkgroups AND conventional radio channels cannot be
programmed into the same system. If a radio has both talkgroups and
conventional channels in it, you will have to select one system for talkgroups and
another for conventional channels.
3.
GROUP/CHANNEL SELECTOR RAMP CONTROLS AND PROCEDURES
A. The GROUP/CHANNEL selector ramp control, located on the lower left of
the radio face (to right of volume ramp control) is used to select your desired
group or channel.
B. Press the “+” end of the ramp control to ascend through groups/channels or
press the “-” end of ramp to descend through groups/channels. The display
(above) will show the selected group/channel. San Francisco Fire Department
primary tactical channel is System 1, Talkgroup 1. San Franciso has a total of
2 channels on system 1 in which the other channel may be used for a 2nd
incident occurring at the same time, ICS, EMS, etc. In addition, channels 1113 are available for use.
C. NOTE: This ramp control is also used to ADD/DELETE groups or channels
to/from the scan list (see section 5 below) and to increment or decrement
systems (see section 2 above).
4.
PUSH-TO-TALK (PTT) BUTTON (ON HAND MICROPHONE ATTACHED TO
FRONT OF RADIO)
A. To transmit, press the PTT BUTTON, wait for the channel access BEEP
TONE then talk into the microphone.
B. Releasing the PTT BUTTON returns the radio to the receive mode.
5.
SCAN ON/OFF BUTTON AND SCANNING PROCEDURES DO NOT USE
6.
BUILDING A SCAN LIST DO NOT USE
I-18