Download Quantum with Unity Pro

Transcript
Parameter Configuration Window
The following table provides an overview of the general module parameters and
their default values.
Name
Default value Options
Meaning
Mapping
WORD (%IW- 3X %MW-4X)
The default value cannot be changed because the ERT 854 10
module normally reads the raw values from the input words
(%IW-3X) and writes them to the output words (%MW-4X).
Input starting
address
1
-
Input starting address
Input ending
address
7
-
The ending address for the inputs results from the starting
address for the inputs plus 6 because the module occupies
seven %IW registers.
Output starting 1
address
-
Output starting address
Output ending
address
5
-
The ending address for the outputs results from the starting
address for the inputs plus 4 because the module occupies five
%MW registers.
Task
MAST
MAST/FAST/
(AUX0/AUX1/
AUX2/AUX3 only
with CPU 651 50)
MAST = Master Task is assigned
FAST = Fast Task is assigned
AUX = AUX Task is assigned
The settings for MAST/ TASK/ AUX are defined during CPU
configuration.
Module No.
0
1... 127
User defined, inserted in event message. The uniqueness of the
value is not checked. 0 = Default, no selection made
Clock
DCF/GPS
Clock
DCF/GPS Clock
External synchronization in DCF77 format by the DCF or GPS
clock.
Internal clock
Telegram synchronization. The clock runs either without
monitoring or is monitored within a validity reserve.
MODULE:
Validity
reserve
1 hour
No
Internal clock is deactivated
1 ... 254 hours
Internal clock: Time from the last synchronization until setting
the TU bits and the time until the time stamp becomes invalid.
0
Internal clock: 0 = free run mode without elapsed time (TE/TU
bits are not set)
1 ... 5 hours
DCF/GPS Clock: 1 hour recommended
53