Download Technical Manual (eng) - ELAN - Certification

Transcript
Drill Template AMBITION
Paper template
Art. No. 163011
1
2
4
1.
3
Drill template Ambition Art. No. 163000
Pict. 02
COMPATIBILITY
Presently the drill template AMBITION can be used for:
Ambition 12
Ambition 10
All AMBITON bindings come with 8mm penetration screws
and can be used with skis of groups G1 & G2. Drill template
AMBITION can be used for ski widths from 75 to 125mm. For
other skis use the template adapter set (Art. No. 162569).
With this adapter set, skis from 61 to 149mm can be mounted.
Alternatively, the use of the attached paper template is also an
option
NOTE: There are different types of brakes. Refer to the
brake overview on page 33 for brake and binding
compatibility.
The description of the brakes always includes a number
and a color-letter code. This number stands for the
maximum ski width in the brake area and not in the ski
center! The color letter code defines the brake segment.
2. POSITIONING OF THE TEMPLATE
There are two ways to mount AMBITION bindings. Either with
the solid jig (Art. No. 163000) or with the paper template (Art.
No. 163011), which is included in the packaging of each
binding. We will show both procedures. First of all, make sure
that the boot is satisfying the international standards and has
no functional damage. Determine the boot sole length with the
Rental caliper (Art. No. 162617).
Pict. 01
Release the handles and ensure that the template is evenly
seated against the ski’s top surface. Select the right holes!
The front holes are identical for both versions (Retail and
Rental - red-silver bushings). You just have to select the right
bushings for the rear holes:
Version
Color of bushings
AMBITION Retail
silver
AMBITION Rental
red
2.2 PAPER TEMPLATE
Align the boot midsole indicator (RETAIL or RENTAL) for the
appropriate boot sole length with the midsole mounting mark
on the ski. Fix it with a sticky tape and ensure that the
template is centered and evenly seated against the ski’s top
surface.
Pict. 03
NOTE: Keep in mind that some ski manufacturers do not use
the center of boot sole location method. Always follow their
instructions.
2.1 DRILL TEMPLATE
Adjust the boot sole length on the template - open it by pulling
the locking lever (1) to the left position. Slide the template to
the right length position and push the locking lever (1) to
middle position. Slide the template to closest centimeter mark,
until it snaps into position. Place the template on the ski and
center the jig. Therefore open the clamping jaws (2) by
rotating the clamping handles (3) and then place the template
on the ski. Therefore select the right midsole indicator on the
template (Black for RETAIL and Red for RENTAL version),
align the indicator with the midsole mounting mark on the ski.
After that you can mark the correct positions with a punch
(Pict.04) for front and rear position. For Retail Version use the
circle-indicator and mark the closest centimeter position. For
Rental version use the quad-indicators.
Pict. 04
45