Download TOUGH2 example manual

Transcript
Five Spot Geothermal Production and Injection (EOS1)
(or click
on the toolbar).
To set the initial conditions
1.
Select the Two-Phase (T, Sg) state option.
2.
In the Temperature box, type 300.0.
3.
In the Gas Saturation box, type 0.01.
4.
Click OK.
Selecting a two-phase initial state with a very small gas saturation is an appropriate
simplification for this geothermal analysis. Since we have only one element in the vertical direction, we have selected a temperature of 300 C as a typical for this reservoir.
The pressure will be calculated to correspond to the small gas saturation. Having all
cells in a two-phase state will also reduce the number of state transitions (two-phase to
single-phase or single-phase to two-phase) that make convergence more difficult.
Define Production Cell
The total injection/production from each five spot pattern is 30 kg/sec. Since we are
using quarter symmetry, the production and injection mass flow rates will be 7.5 kg/
sec. In this analysis, we will define injection and production in specific cells using the
Grid Editor. To open the Grid Editor, on the Model menu, click Edit Grid (or click
on the toolbar).
To define the production cell
1.
Using the Selection tool, Right-click on the upper right cell.
2.
Click Edit Properties....
3.
In the Cell Name box, type Production.
4.
Click the Sources/Sinks tab.
5.
Under, Production, select the Mass Out checkbox.
6.
In the Rate box, type 7.5.
7.
Click the Print Options tab.
8.
Select the Print Cell Time Dependent Data check box.
9.
Click OK to close the Edit Cell Data dialog.
You will now see Production as the cell name and also S and P. The S indicates that
the cell is a source/sink. The P indicates that detailed 2D cell history results plots will
be available for this cell.
5