Download MANUAL - silmaq

Transcript
Error Type
Poor detection
of upper thread
Bad jump
Bad stitch
Cause
Inspection & Repair
① Failure of thread detecting
roller
Disassemble the roller and clean
the roller and bush bearing.
② Poor connection & quality
of tension adjusting board
Check board connection and
change the circuit board
① Bad SMPS for jump
Change front fuse
controller box
② Bad wiring for jump motor
Bad jump motor
Check wiring and change jump
motor
③ Bad connection
Check connection
④ Switch failure on tension
adjusting board and bad
circuit board
Change switch and circuit board
① Bad design
Correct tape
② Inadequate tension on X-Y
belt
Adjust tension
③ Foreign substance in X-Y
rail
Clean the rail
④ Failure of X/Y driver
Change circuit board
⑤ Heavy load on frame
Reduce speed of main shaft
rotation
12-3
,
in
Reference
Check fuse spec
1) 3-phase:
,
= 250V 15A
2) 1-phase:
,
= 250V 30A