Download USER`S MANUAL
Transcript
BASIC TIMER and TIMER 0 S3F80P9_UM_ REV1.00 TIMER 0 FUNCTION DESCRIPTION Timer 0 Interrupts (IRQ0, Vectors FAH and FCH) The timer 0 module can generate two interrupts: the timer 0 overflow interrupt (T0OVF), and the timer 0 match/ capture interrupt (T0INT). T0OVF is interrupt with level IRQ0 and vector FAH. T0INT also belongs to interrupt level IRQ0, but is assigned the separate vector address, FCH. A timer 0 overflow interrupt (T0OVF) pending condition is automatically cleared by hardware when it has been serviced. The T0INT pending condition must, however, be cleared by the application’s interrupt service routine by writing a “1” to the T0CON.0 interrupt pending bit. Interval Timer Mode In interval timer mode, a match signal is generated when the counter value is identical to the value written to the T0 reference data register, T0DATA. The match signal generates a timer 0 match interrupt (T0INT, vector FCH) and clears the counter. If, for example, you write the value ‘10H’ to T0DATA, ‘0BH’ to T0CON, the counter will increment until it reaches ‘10H’. At this point, the T0 interrupt request is generated. And after the counter value is reset, counting resumes. With each match, the level of the signal at the timer 0 output pin is inverted (See Figure 10-4). IRQ0(T0INT) Pending (T0CON.0) Interrupt Enable/Disable (T0CON.1) CLK 8-Bit Counter (T0CNT) 8-Bit Comparator Buffer Register T0CON.3 R (Clear) Match CTL P3.0/T0CAP T0CON.5 T0CON.4 Match Signal T0CON.3 Timer0 Data Register (T0DATA) Figure 10-4. Simplified Timer 0 Function Diagram: Interval Timer Mode 10-6