Download Panel-Envelope

Transcript
Panel-Envelope – User Manual
Inclusion Data Commands
Inclusive Command :
CHOO
Syntax
:
CHOO S/D S/U/B minnum maxnum (text)
Examples
:
CHOO S U 0 10 CHOOSE 0 TO 10
CHOO D S 1 1 CHOOSE ONLY 1
Description:
The CHOOse command is used to specify a choice or selection of a certain number of the
following inclusion data lines as part of the envelope. The list of following commands may
only include LOAD, USE and WITH commands; all others are invalid in this context and
will cause the CHOOse list to be terminated. The first following command must be a
LOAD instruction and there is currently a list length limit of fifty lines.
The S/D (Static/Dynamic) flag must be consistent with the sub-deck being defined. Either
S or D is allowed in the COMBINED section.
The S/U/B (Service/Ultimate/Both) flag defines the type of envelope that will be extended
by this command. The B flag is not permitted in the COMBINED sub deck, but may be
simulated by extending the service and ultimate envelopes separately.
The 'minnum' and 'maxnum' parameters define the minimum and maximum numbers of
following load cases that will be selected to extend the envelope. No less than 'minnum',
and no more than 'maxnum' of the following cases will be used for each load, for each
location. The following restrictions apply:
−
−
−
minnum may not be less than zero;
maxnum may not be less than minimum;
maxnum may not be greater than the number of following load cases.
The worst of the following cases are always chosen, in the sense of those cases that extend
the envelope furthest, if there are more than maxnum cases that extend the envelope, only
the worst maxnum cases will be chosen. If there are between minnum and maxnum cases
that extend the envelope, then only those cases will be chosen. If there are less than
minnum cases that extend the envelope, then minnum cases must still be chosen. Note that
this may cause the selection of cases that actually contract the envelope. If this is the case,
those such cases will be multiplied by their ultimate factor to reduce the envelope by the
minimum amount (see Section 2.7).
Up to twenty characters of text may be input at the end of the line as an aid to describing
the data.
Contains proprietary and confidential information of ANSYS, Inc. and its subsidiaries and affiliates.
6-2