Download Secure-T

Transcript
Abstract
This project is an undertaking to create a full duplex combination encryption
device and DS1 framer. The hardware receives the combined output from the 24
channels, encrypts this data using the 3-Way encryption algorithm in Cipher Feedback
Mode (CFB), assembles it into DS1 193S frame format, and then outputs this to a
standard Line Interface Unit (LIU) T1 interface chip, the CS61310. This data could then
be securely transmitted across any T1 line and the user at the other end could then use
another similar device to receive the data and decrypt it, provided they are aware of the
key. The project has been fully simulated and the results from simulation have been
compared to output from C/C++ programs that implement these algorithms. The
successful design was implemented on an Altera 10K20 FPGA found on an Altera UP1
board. This system was tested to verify complete functionality and the design was found
to operate correctly. The framing was found to be compliant by both a Super T1 ISA
card and a TauTron DS1 tester. Frame synchronization could also be found with these
sources. The encryption and decryption routines were also successfully implemented.
Ian Kuon
Mark Calder
Secure-T
Page 3 of 54